pituitary axis comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Updated 2026-02-07. Numbers and descriptions here follow the published literature rather than marketing material.
Tesamorelin is a synthetic peptide that belongs to the growth hormone-releasing hormone (GHRH) family. Its sequence corresponds to the fully active 44-amino-acid form of human GHRH, with a single structural modification: the addition of a trans-3-hexenoyl group at the N-terminus. That modification is not found in the naturally occurring hormone and was introduced deliberately during development to improve stability against enzymatic degradation. The compound is therefore best described as a stabilized analogue rather than a naturally occurring peptide.
The native hormone is produced in the hypothalamus and acts on the anterior pituitary. Binding of GHRH to its receptor stimulates synthesis and release of growth hormone into circulation. Because the analogue retains the receptor-binding region of the parent sequence, it engages the same receptor and triggers the same downstream signaling. The result is increased growth hormone secretion from pituitary cells, which in turn influences hepatic production of insulin-like growth factor 1. This axis is the basis for the compound's measured biological effects.
Quantitation of the peptide relies mainly on reversed-phase high-performance liquid chromatography with ultraviolet detection, typically at 214 nanometers, where the peptide bond absorbs. Identity is confirmed by mass spectrometry, most often electrospray ionization coupled to liquid chromatography, and by peptide mapping after enzymatic digestion. Because related impurities differ only slightly in sequence or modification, method development emphasizes resolution rather than speed. Purity is usually reported as a percentage of the main peak area, with individual impurities listed separately when they exceed a defined reporting threshold.
Stability testing examines how the molecule changes under controlled stress. Thermal stress, light exposure, and extremes of pH are applied separately so that each degradation route can be attributed to a specific cause. The main observed changes are oxidation, deamidation, and aggregation into dimers or higher-order species. Accelerated studies at elevated temperature are used to estimate behavior over longer periods, though such extrapolation carries uncertainty. For a lyophilized powder, residual moisture and the choice of bulking agent strongly influence how quickly these changes appear.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C221H366N72O67S | Reflects a 44-residue peptide with one N-terminal modification |
| Approximate molecular weight | 5136 Da | Sequence length and single acyl group determine the mass |
| Appearance | White to off-white lyophilized powder | Typical form of a purified synthetic peptide |
| Solubility class | Soluble in water and aqueous buffer | Peptide backbone favors aqueous dissolution |
| Common synonyms | GHRH(1-44) analogue; Egrifta | Descriptive name and approved brand name |
Tesamorelin is a synthetic peptide of 44 amino acids that reproduces the sequence of human growth hormone-releasing hormone (GHRH) and carries a trans-3-hexenoyl group on its N-terminal tyrosine. That small fatty-acid modification blocks cleavage by dipeptidyl peptidase-4, the enzyme that rapidly degrades native GHRH in plasma. The result is a molecule with a longer circulating half-life than the natural hormone while retaining the same receptor target. It is supplied as a lyophilized powder for reconstitution and belongs to the broader class of GHRH analogs studied for effects on pituitary growth hormone secretion.
Development work on the compound, originally designated TH9507, focused on conditions in which reduced growth hormone signaling is thought to contribute to altered body composition. The United States Food and Drug Administration approved it in 2010 for the treatment of excess visceral abdominal fat in adults with human immunodeficiency virus infection and lipodystrophy. Later research examined other populations, including adults with mild cognitive impairment, where a large trial did not meet its primary endpoints. This mixed record illustrates how a single mechanism can produce clear effects in one setting and inconclusive results in another.
特沙莫瑞林的检测通常依赖反相高效液相色谱和质谱联用。反相色谱可分离肽主峰与缺失序列、氧化产物等杂质，质谱则提供精确质量以确认身份。对于复杂基质中的定量，常采用液相色谱-串联质谱，并配合固相萃取或蛋白沉淀。生物样品中的肽易降解，因此采集和处理条件会影响结果。
稳定性研究通常考察温度、光照、湿度和 pH 对肽链的影响。冻干粉在低温避光条件下较为稳定，复溶后则需控制保存时间并避免反复冻融。肽类可能发生氧化、脱酰胺、水解和聚集，这些变化会改变色谱纯度。强制降解实验用于识别主要降解途径并验证分析方法的专属性。
=== Effects on drug metabolism and drug interactions === The enzymes that are defective in GS – UDP glucuronosyltransferase 1 family, polypeptide A1 (UGT1A1) – are also responsible for some of the liver's ability to detoxify certain drugs. For example, Gilbert syndrome is associated with severe diarrhea and neutropenia in patients who are treated with irinotecan, which is metabolized by UGT1A1. While paracetamol (acetaminophen) is not metabolized by UGT1A1, it is metabolized by one of the other enzymes also deficient in some people with GS. A subset of people with GS may have an increased risk of paracetamol toxicity. Another drug that has increased adverse side-effects in individuals with Gilbert syndrome is atazanavir. Atazanavir is a protease inhibitor for the treatment of HIV. Atazanavir can lead to jaundice in individuals with Gilbert syndrome because it further inhibits the UGT enzymes that already exhibit decreased activity in Gilbert syndrome.
== Honors and awards == Meldal was awarded the 2022 Nobel Prize in Chemistry, jointly with Carolyn R. Bertozzi and Karl Barry Sharpless, "for the development of click chemistry and bioorthogonal chemistry".
== Cause == Mechanical tension on a wound has been identified as a leading cause of hypertrophic scar formation. When a normal wound heals, the body produces new collagen fibers at a rate that balances the breakdown of old collagen. Hypertrophic scars are thick, red to brown in coloration, and may be itchy or painful. They do not extend beyond the boundary of the original wound but may continue to rise or thicken for up to six months. Hypertrophic scars usually heal and fade over one to two years. Hypertrophic scars may cause distress due to their appearance or the intensity of itchiness. They can also restrict movement if located close to a joint. Some people, such those with Ehlers–Danlos syndrome, may have an inherited tendency to develop hypertrophic scarring.
Sources: en.wikipedia.org
In the first case of a woman being sentenced to death in Singapore, dance hostess Mimi Wong Weng Siu was convicted of murdering Ayako Watanabe out of jealousy in 1970 and received the death sentence in the same trial as her ex-husband Sim Woh Kum, who assisted her in killing the Japanese victim, who was the wife of Wong's Japanese boyfriend. The couple were executed on 27 July 1973.
=== Shape === Circulating inactivated platelets are biconvex discoid (lens-shaped) structures, 2–3 μm in greatest diameter. Activated platelets have cell membrane projections covering their surface. In a first approximation, the shape can be considered similar to oblate spheroids, with a semiaxis ratio of 2 to 8. This approximation can be used to model the hydrodynamic and optical properties of a population, as well as to restore the geometric parameters of individual measured platelets by flow cytometry. More accurate biophysical models of platelet surface morphology that model its shape from first principles make it possible to obtain a more realistic platelet geometry in a calm and activated state.
The oil diffusion pump is operated with an oil of low vapor pressure. The high speed jet is generated by boiling the fluid and directing the vapor through a jet assembly. Note that the oil is gaseous when entering the nozzles. Within the nozzles, the flow changes from laminar to supersonic and molecular. Often, several jets are used in series to enhance the pumping action. The outside of the diffusion pump is cooled using either air flow, water lines or a water-filled jacket. As the vapor jet hits the outer cooled shell of the diffusion pump, the working fluid condenses and is recovered and directed back to the boiler. The pumped gases continue flowing to the base of the pump at increased pressure, flowing out through the diffusion pump outlet, where they are compressed to ambient pressure by the secondary mechanical forepump and exhausted. Unlike turbomolecular pumps and cryopumps, diffusion pumps have no moving parts and as a result are quite durable and reliable. They can function over pressure ranges of 1×10−10 to 1×10−2 mbar (1×10−8 to 1 Pa). They are driven only by convection and thus have a very low energy efficiency. One major disadvantage of diffusion pumps is the tendency to backstream oil into the vacuum chamber. This oil can contaminate surfaces inside the chamber or upon contact with hot filaments or electrical discharges may result in carbonaceous or siliceous deposits.
Sources: en.wikipedia.org
Explorations of artificial materials for manipulating electromagnetic waves began at the end of the 19th century. Some of the earliest structures that may be considered metamaterials were studied by Jagadish Chandra Bose, who in 1898 researched substances with chiral properties. Karl Ferdinand Lindman studied wave interaction with metallic helices as artificial chiral media in the early twentieth century. In the late 1940s, Winston E. Kock from AT&T Bell Laboratories developed materials that had similar characteristics to metamaterials. In the 1950s and 1960s, artificial dielectrics were studied for lightweight microwave antennas. Microwave radar absorbers were researched in the 1980s and 1990s as applications for artificial chiral media. Negative-index materials were first described theoretically by Victor Veselago in 1967. He proved that such materials could transmit light. He showed that the phase velocity could be made anti-parallel to the direction of Poynting vector. This is contrary to wave propagation in naturally occurring materials. In 1995, John M. Guerra fabricated a sub-wavelength transparent grating (later called a photonic metamaterial) having 50 nm lines and spaces, and then coupled it with a standard oil immersion microscope objective (the combination later called a super-lens ) to resolve a grating in a silicon wafer also having 50 nm lines and spaces. This super-resolved image was achieved with illumination having a wavelength of 650 nm in air.
=== Four base (quadruplet) codons === While triplet codons are the basis of the genetic code in nature, programmed +1 frameshift is a natural process that allows the use of a four-nucleotide sequence (quadruplet codon) to encode an amino acid. Recent developments in genetic code engineering also showed that quadruplet codon could be used to encode non-standard amino acids under experimental conditions. This allowed the simultaneous usage of two unnatural amino acids, p-azidophenylalanine (pAzF) and N6-[(2-propynyloxy)carbonyl]lysine (CAK), which cross-link with each other by Huisgen cycloaddition. Quadrupled decoding in wild-type, non-recoded strains is very inefficient. This stems from the fact that the interaction between engineered tRNAs with ternary complexes or other translation components is not as favorable and strong as with cell endogenous translation elements. This problem can be overcome by specifically engineering and evolving tRNA that can decode quadruplet codons in non-recoded strains. Up to 4 different quadruplet orthogonal tRNA/tRNA synthethase pairs can be generated in this manner. Quadruplet codon decoding approach has also been applied to the construction of an HIV-1 vaccine.
=== Influence of contact shape === Even in the presence of perfectly smooth surfaces, geometry can come into play in form of the macroscopic shape of the contacting region. When a rigid punch with flat but oddly shaped face is carefully pulled off its soft counterpart, its detachment occurs not instantaneously but detachment fronts start at pointed corners and travel inwards, until the final configuration is reached which for macroscopically isotropic shapes is almost circular. The main parameter determining the adhesive strength of flat contacts occurs to be the maximum linear size of the contact. The process of detachment can as observed experimentally can be seen in the film.
Sources: en.wikipedia.org
It shares the 44-residue sequence of human GHRH but carries an added trans-3-hexenoyl group at its N-terminus. That addition does not occur in the natural hormone and serves mainly to resist enzymatic breakdown. The receptor target and signaling pathway remain the same.
It binds the growth hormone-releasing hormone receptor on anterior pituitary cells. Activation of that receptor promotes synthesis and release of growth hormone. The effect propagates through the growth hormone and insulin-like growth factor 1 axis.
Native GHRH is cleared quickly by peptidases, which limits how long it can stimulate its receptor. The added group hinders one of the primary cleavage enzymes. The practical consequence is a longer period of receptor activity per dose.
Reversed-phase high-performance liquid chromatography with ultraviolet detection is the standard technique for purity and content. Mass spectrometry provides orthogonal confirmation of identity. The two are normally used together rather than in isolation.